Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi
first off I have a home network, I have a 2821 the g0/0 Ethernet port is connected to my DSL router and is the WAN. I have g0/1 connected to my LAN which has my DHCP,DNS and AD servers and clients connect through a switch.
this is my running confi...
Hi I created a route using the ip route command. I wanted to change one of the ip addresses . I tried doing the command over again, tried the prefix of no, still stays unchanged. also how do you use the search function on this forum and do quotes, ...
I first created a running config/startup config from an example on youtube that enabled a DHCP server on the 2821 router. It worked great , connected a laptop to the router was able to ping and surf the internet. So I disabled the DHCP in the router ...
Hi new to routers. I just purchased a 2821 and from using the console cable I received this info below. I would like to use SDM to configure the router. I believe I use port 0/0 and a crossover cable to a laptop or straight through cat5 to a hub o...
Actually the thread I selected is not the actual "correct" answer it was all combined. I think what was happening was I was going from nat to a firewall and the routing table was getting mixed up I found the best yield was to put the router in facto...
You still have an ACL 103 on the inside interface which is not in your config yeah I missed that will correct it .
The DSL-Router needs to know how to reach your internal network. It's the DSL-device that has to be configured with a route to 10.10.10...
I am starting to understand the logic a little Karsten
I used your example. here is my running config
Router#show running-configBuilding configuration...
Current configuration : 1472 bytes!! Last configuration change at 02:26:13 UTC Thu Sep 29 2016...
I tried this CBAC config now I cant get out of my network. I can ping the next hop ( vz router gateway) can not ping anything on the internet can ping any device on my LAN. What did I do wrong?
Router#show running-configBuilding configuration...
Cur...
