Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Kriver, I've seen some stuff on the roadmap which will probably help with this. Speak to your local Networking SE to get more information on this feature, and timelines for when it will be available. If they're unsure of the immediate answer, plea...
To add to Chris' comments regarding the configuration of the default route for Meraki appliances operating as VPN Type: Hub.The configuration is done on the Secure Connect > Sites pageFrom the list of connected sites at the bottom of the page, click ...
Hi Bucket, it isn't that NAT stops working, it's that the default route installed to the appliance creates an asymmetric route.For sites with resources that need to be accessible from the public internet, you need to either create a VPN exclusion rul...
The Umbrella > Network Tunnels page should only be referenced for IPsec connectivity today. The Secure Connect-[DC location] tunnels you see on the page are not indicative of any AutoVPN tunnels. For AutoVPN tunnel status, please leverage the Meraki ...
