About RWelch-USA

RWelch-USA · 05-15-2026

Apparently I missed the announcement of these:C8111-C-G2-MX, C8121-W-G2-MX, and C8121-CW-G2-MX Data Sheet

RWelch-USA · 05-13-2026

Sharing in case folks are about to make a bulk purchase or are in need of renewals. Meraki End-of-Life (EOL) Products and Dates

RWelch-USA · 05-12-2026

Not sure how recent the 5GHz (Dual) column was added but sharing for those that might be interested, I just noticed it myself (today).Dashboard > Wireless > RF Spectrum (select COLUMN) to tailor to your network:

RWelch-USA · 02-11-2026

I've not had problems in the past with submitting feedback however today it's quite problematic in trying to provide feedback with the error seen above. My feedback was fairly short with no special characters, nothing pasted.Same error regardless of...

RWelch-USA · 01-28-2026

Seems like this is happening again.Anyone else experiencing this with the dashboard?Your session is about to expire!You will be logged off in seconds.Do you want to continue your session?

RWelch-USA · 06-05-2026

If this were my project, I'd be inclined to solve the problem with more APs at lower power than fewer APs at higher power plus RX-SOP.While RX-SOP receiver sensitivity threshold is amazing for high-density auditoriums, using it to fix a coverage prob...

RWelch-USA · 06-04-2026

If there are truly zero UDP/500 or UDP/4500 packets leaving either side, then initiation/routing is the leading suspect.If you see IKE packets being exchanged, then the issue is less likely to be connectivity and more likely to be a configuration mis...

RWelch-USA · 06-04-2026

Have you tried to send pings from each box to the other to establish a connection?

RWelch-USA · 06-03-2026

You said:This behavior is limited to a specific building and random MR46 APs. However other locations with the same AP model and firmware (32.1.6) are not experiencing this issue.Are all APs using the same (or different) RF Profiles?

RWelch-USA · 05-22-2026

You can deploy a full-stack Unified Branch within couple minutes through two methods: using the Meraki dashboard interface or leveraging the AI Assistant.Unified Branch

Member Since	‎11-03-2024 10:39 AM
Date Last Visited	‎06-05-2026 11:18 AM
Posts	1,312
Total Helpful Votes Received	2159

User Statistics

User Activity

New Hardware?

MT Sensors: End of Sale 11/10/2026

New: RF Spectrum 5GHz Dual

Unable to provide feedback

Dashboard: Your session is about to expire! 1/28/2026

Re: RX-SOP Design Considerations for Mixed Handheld and Laptop Environ

Re: Ipsec VPN Meraki MX and Watchguard Firewall

Re: Ipsec VPN Meraki MX and Watchguard Firewall

Re: 5Ghz band is 100% utilized due to non 802.11 traffic.

Re: Cisco Meraki