Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm working on creating an SSL decryption policy, but I'm running into an issue where the "no decryption" rule is failing to prevent decryption.Interestingly, if I configure the "no decryption" rule using a subnet address, it works as expected. Howev...
Hello!I can successfully connect to the VPN using Remote Access and access all hosts in the 192.168.100.x subnet.Now I'm trying to manage the FDM remotely. After connecting to the VPN, I attempt to access the FDM's data interface IP (192.168.100.1), ...
Hello !I'm trying to configure a VPN for remote access.On the client side, I'm attempting to connect to the server using its IP address and port number, both of which are correct.I can ping the public IP of the server.However, the connection fails, ...
Hello!I've been trying to figure out the best approach for applying IPS inspection.Suppose I don't have any internal services or servers exposed to the internet — meaning no port forwarding from Outside to DMZ or Outside to Inside. In that case, does...
Hello,I've successfully configured an external syslog server on FDM, and it's receiving messages correctly. I've set the Default Action Block to send syslog messages, and those are arriving as expected on the external server (among other messages).Ho...
I would agree that it could be a problem, firewall not being able to look at the certificate and match URL, but it was working prior to upgrade to 7.6.2, so maybe is anoter sort of problem. I'll reset the firewall and try again with the previous vers...
Thank you, I'm probably going for a jump server solution.why cisco workaround not work ? not sure, I can't even ping the FTD interfaces when inside VPN.Strange that other hosts on the same subnet are fine. Its seems a blocked feature.
Thank you all. Just for the record, TAC advised me to use the Data Interface for management, but that didn’t work either.a. Open Device > System Settings > Management Access.b. On the “Data Interfaces” tab click “+”.- Interface – pick the interface t...
I see, even a ping to FDM interfaces over VPN seems to be blocked with no reason, but I couldn't find official informations about this. What are the options ? connect to a remote client first (like a jump server) and manage FDM from that ?
