Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear all,
I have questions like a subyek.
We have 2 server Ucs 240 M4 , both of spesification is same. The server have 2 disk (2*600gb) and using raid 1 configuration.
We already installed os (Rhel 7.2) in one of server and config everything in her...
Hello Everyone,
I have a problem about my Server UCS B200 M4 , there are 2 alert that is "DIMM D3 on server x/y operstate disable" and "DIMM H3 on server x/y operstate disable". I've checked on inventory tab, memory is still detected but the capac...
Hi Community , I have a problem when finished up Install Windows Server 2012 , when server reboot the server getting fail " failed to find the bootable device"Server Cisco UCS C Series 220 M3 , i am boot using local disk , configured boot UEFI mode ...
Hi master ,I want to ask some thing, currently i am install Windows Server 2012 on Cisco UCS C-Series 220.I am install OS, using enable Bios UEFI Configuration , but after finish setup OS and reboot than OS cannot boot or but failed? Any body help m...
Hi Qiese Dides,
Maybe tomorrow i will try swap the memory sticks , for make sure the problem depend from memory stick or slot . And i will inform for the result.
We running with UCSM 2.2(6c) , and we already doing reset all memory errors , and nothi...
Hi Timothi,Sorry for late replay , the version of CIMC is 2.0 .Yes, i am format the disk , first deleted the existing partition, and create again . And then installed WinServer 2012 at the new partition are created. Setup is finish , after reboot can...
Hi Timothy,UCS C Series C220 M3 , i am using local boot disk. And managed using CIMC .Actualy if i enable UEFI in Bios config ? Is it true the configured boot mode also UEFI not Legacy?I am so sorry , i am newbi in UCS Server.Thanks for your answer
