Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
The CLI enable command for an interface is rejected on my switch. I did not expect this, is it normal for this switch? I am on IOS 17.12.05
Switch#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)#inter...
It is interesting that "Configuring Hundred Gigabit Ethernet Interface" in the Interface and Hardware Components Configuration Guide (about pg 61) step 4 is a command that says this: 'Device(config-if)# enable' I've also used it on a previous C9500...