Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a config on a usb stick called ciscortr.cfg. In this config I have a eem applet that I want to run to configure the outside interface. But this applet will not run because the setup dialog "Would you like to enter the initial configuration dia...
If I copy a file from the 881 router without VRF it takes 0.776 secs (180 bytes/sec) to copy 140 bytes.
I setup VRF and set my Ip ssh source-interface to FastEthernet4 it takes 11.188 secs (13 bytes/sec) to copy 140bytes.
In both I copied the same ...
I have been able to get https to work from IOS command using copy or more. I have also able to get http gets and posts to work form TCL scripts. But what I need to get to work from TCL is Secure HTTP (https). I am using a 881-W Router. The http.tcl f...
check to see if you device supports the new vrf definition
conf t
vrf definition ?
If it does change to vrf definition from ip vrf.
I found this speeds up scp.
Bharat, This is what I want to do.
1. do a "wr erase"
2. ship the router to a site.
3. put a usbkey that has a config and an eem applet on it.
4. insert a network cable to a network that does not have a dhcp server.
5. turn on the router without a co...
