It appears to be working now. Would that bandwidth setting for GRE have to be set if you are using the pptp server in the router? Also why do you have to set this up, isn't that was PPTP passthrough is supposed to do? ... View more

we could use another rv042 as the other endpoint though? ... View more

problem is your quickvpn does not support server 2003 R2 does it? ... View more

I am actually attempting to use the MS VPN client as that is a requirement by the software vendor. I only have the default firewall access rule which is set to allow all traffic. I figured since I was using the vpn tunnel in the router I would not need to create any access rules for that. I am stuck on getting this error: Quick Mode I1 message is unacceptable because it uses a previously used Message ID ... View more

So I managed to get close using the ms client. I setup a group vpn with remote client as windows client group2 3des sha1 (settings as ms states for defaults) set that for both phases, I get through main mode fine, but then it goes to quick mode and its telling me Quick Mode I1 message is unacceptable because it uses a previously used Message ID any suggestions? ... View more

but the clients office is closed, I do mostly remote support. so I need to figure this out remotely. That IS what this forum is for correct? ... View more

I apologize but I do not have the ability to call during business hours so I need to resolve this on the forums. I am working on setting this up with the microsoft VPN client connecting from Server 2003. I have configured the machine I am connecting from (server 2003) as 192.168.38.x and the routers network is 192.168.1.x I set the protocol in the client to l2tp. Remote gateway is set to allow the ip of the server 2003 (Client) agressive mode is off. I am getting the following errors in the log Nov 9 10:09:36 2009     VPN Log    (NATT)Initial Main Mode message received on 96.x.x.x:500 but no connection has been authorized. Please check your tunnel endpoint (gateway) setting  Nov 9 10:09:36 2009     VPN Log    Dynamic VPN client in Main Mode is only supported for Microsoft VPN client, please use Aggressive mode instead. Not sure where to go from here, I AM using the Microsoft VPN client so I am not sure why it is telling me to use agressive mode, (also tried checking agressive mode but get the same error) ... View more

UPDATE: Got the quickvpn log from the client 2009/11/04 15:29:03 [STATUS]OS Version: Windows XP 2009/11/04 15:29:03 [STATUS]Windows Firewall is OFF 2009/11/04 16:29:03 [STATUS]One network interface detected with IP address 10.x.x.x 2009/11/04 16:29:03 [STATUS]Connecting... 2009/11/04 16:29:03 [STATUS]Connecting to remote gateway with IP address: 96.x.x.x 2009/11/04 16:29:09 [STATUS]Remote gateway was reached by https ... 2009/11/04 16:29:09 [STATUS]Provisioning... 2009/11/04 16:29:14 [STATUS]Remote gateway was reached by https ... 2009/11/04 16:29:14 [STATUS]Provisioning... 2009/11/04 16:29:14 [WARNING]Failed to connect! ... View more