Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I am going to be upgrading from ASA 5516's (x2) to FTD 3105's which are managed by vFMC 7.6.2 in a few days. One of the ngfw technologies I am hoping to leverage is FQDN blocking on this new platform. I am reading conflicting reports about usin...
Hey everyone,I'll start off by saying I am new to Firepower, but experienced in ASA and CLI. I have configured 2 FTD 3105's managed by FMC and ported over the old ASA 5516 config over to the Firepower unit. Recently had an issue cabling the new FTD's...
Good morning everyone,My company recently purchased 2 3105 FTD's, which I currently have staged ready to begin configuration. Yesterday I spun up a vFMC in our vmware cloud and attempted to transfer mgmt of FT-DFW01 to the vFMC. FMC & the FTD were on...
Hello, I recently started new employment, and one of my 1st tasks is to flip over from ASA 5516's to Cisco FTD 3105. Setting these up is unlike any other firewall I have previously worked with, so I have some really dumb questions. When I first boote...
Hello, 1st time posting here so hopefully this proves useful to others. I recently took over management of 2 5516 ASA's (9.16). This company currently has 3 WAN interfaces with these ip addresses: "FIOS (A.A.A.A), FIOS_1G (B.B.B.B) & comcast (C.C.C.C...
And just an added reply to anyone else search this thread, looking for a simple solution. From my little bit of research Cisco FMC logic does differs from Fortinet fundamentally in its approach to wildcard and URL filtering in general. Basically Fort...
Thank you both for taking the time to answer on the holiday. And the answer was as I figured. I have figured out a 'work-around' solution to my problem...for the mean time, as I have admin access on all layers of the network. Once again thank you bot...
Thanks Aref. It is there after all, I was missing it. For those who look at the Link Aref provided, the "Switch Active Peer" option, on task 4 in the link above, is not found by clicking the edit "pencil", it found by clicking the 3 vertical dots jus...
Hi, thanks I did that initially, and it worked. Ran into a little problem because I was using data-interface for management traffic, but it did enable local FDM management on the firewall itself. Appreciate the community! Thank you this has been reso...
Thanks for the reply MHM. I was able to regain access to the FTD through console and eventually through the predefined "inside" interface, Eth2, which comes preconfigured as 192.168.95.1/24. Once I had that, I configured data-interface Eth1/8, as my ...
