Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good day to all!I am currently installing a Cisco 1841 router with a WIC 1T CSU DSU on a branch office with around 5 workstations on the LAN. WAN BW is 256kbps fractional T1 to a MPLS VPN going to our hubsite. I tried to test the connectivity to our ...
Mjonkers,I would like to suggest that you configure the inside interface as the management-access interface. Include the inside interface IP and syslog server IP address on the NAT 0 ACL and crypto ACLS.You can checkout the "management-access" when ...
Joseph,Here is where I see that 192kbps available bandwidth:show int s0/0/0Serial0/0/0 is up, line protocol is up Hardware is GT96K with integrated T1 CSU/DSU Description: $FW_OUTSIDE$ Internet address is 10.27.19.1/30 MTU 1500 bytes, BW 256 Kbit...
joseph,Hi!I have configured the the following on the router interface:interface Serial0/0/0 ip address 10.27.116.1 255.255.255.252 encapsulation ppp no peer neighbor-route service-module t1 timeslots 1-4 no cdp enableBut when I verify the serial inte...
