Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI have two queries: First - We have an FWSM in 6500 with FW OS 3.2(12). It allows only 1 vlan (SVI) to assign to firewall vlan-group. If I want to assign more than 1 vlan, I need to add this command "firewall multiple-vlan-interfaces". The document...
HiWe have LMS 2.5 with CM, DFM, IPM, RME. We have LAN and remote branches connected thru MPLS. Frequently WAN link goes down. We want to know when there is a link failure thru alerts. Is it possible to monitor WAN links using LMS? If yes, how to do t...
Hi Jon,Actually I rolled back to original config and right now fwsm is not functional. I added the following route to MSFC when fwsm was working:ip route 0.0.0.0 0.0.0.0 vlan61Vlan61 is the SVI interface between msfc and fwsm.I checked this show ip r...
Hi Jon,Thanks a lot, though you are in busy schedule, you replied to me. I am attaching herewith the FWSM config. I did static NAT, just to verify whether this solve the issue or not. Nat-control is disabled, icmp inspection allowed. I was trying to ...
Hi Jon,Sorry for the delay in reply and thanx for the details. I tried to deploy FWSM at the weekend, it was partially successful.The topology was Internet -> pix -> vlan 30 <- FWSM -> vlan 20 <- MSFC -> inside vlans; vlan 40 as DMZI was able to acce...
Hi Jon,Thanks for your prompt reply. Actually we want to firewall among all VLAN's because we need to restrict access between them as well as to other segments. But, my concern to firewall all VLAN's, by thinking that it might require to remove SVI's...
