Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey Jay,The one that springs to mind is the CCIE Sec transition from v3 to v4 and the inclusion of ISE, Ironport and a few others.Also I'd like to hear your take on the ASA-CX series.Cheers,Rich
Hi Jeremy,There can be a number of things, firstly I'd say check the following1) Are you running nat-control (sh run nat-control)2) Do you have any nats setup ( sh run nat, sh run global, sh run static)3) Check your inside access-list if defined, if ...
Hi,Check the cable, check that its a straight through and not a X-over if its going to a switch.Check the switches port has been brought up and check that speed and duplex match on both the ASA and the Switch.Cheers,Rich
