Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,Very much a novice question, but i am having problems getting traffic to route across vlans on my C1300 switch. I have done the following from both web interface and CLI interface at separate times without success:Created VLAN 10Created VLAN 20...
Hello Kris, Thanks, I wasn't aware of this. I have pulled out some other network components to test with, instead of messing about with firewalls, etc. I picked up a device, set it to have IP address 192.168.20.23 /24, gateway address 192.168.20.1 an...
This is my VLAN settings:Clearly there are a few more VLANS configured than i mentioned, but the problem is the same across all of them so i tried to simplify the question.Port allocations: This is the IPV4 page:
