Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am having slow application performance thru a site to site VPN. I am running MS SQL and Oracle database applications thru the tunnel. I have a 10 MB pipe from the ISP on both ends of the pipe. These are different ISPs. I have done speed tests a...
I have recently changed some of the routing on my ASA 5540 and I am routing ip address 172.16.0.25 thru a different interface than all of my other traffic. I can get to this IP from the inside interface and also from the DMZ but I cannot get to it w...
I am looking for some advice on how to properly setup a site to site VPN when there's overlapping subnets. i.e. if you have 172.16.x.x on both sides of the tunnel.I have set this up before and here's my config but I'm not sure if this is the best wa...
I have a Cisco 6513 switch that performs inter-vlan routing. I have a series of Cisco 3750 switches and a 3560 switch connected to the 6513 via trunk links. (4 3750 switches and 1 3560)I am having trouble with ping/telnet from a desktop PC located...
I have a Cisco 3560 switch and I have configured a port as a trunk port like this:switchport mode trunkswithport trunk encapsulation dot1qI also have an Intel Network card PRO 1000 GT in a desktop computer and I have configured multiple VLANs on the ...
I have a speed issue along the same lines. Mine is a little different however because I have a 10 MB pipe from the ISP and I have a site to site VPN. The speed thru the VPN is 10 MB but the application performance thru the VPN is very poor. I'll p...
Ok, I made a little progress. I setup an "untagged" VLAN on the NIC and then I also setup VLAN 260 on the NIC. On the switch side, I setup VLAN 100 as the native VLAN. VLAN 260 seems to work as received a DHCP address on that VLAN. However, VLAN...
