Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am working on a Cata switch, i am working on bonding ports for increased bandwidth (trying to bond 2 1gb interfaces for 2gb of bandwidth)if i recall coorectly i need to create a channel and then configure both intercaes to use that channel, then ta...
I have a cisco pix 506 and 9 cisco pix 501's the pix 506 is the main firewall that all the 501's VPN into... I have started logging on my pix 506:ABVALVE-PIX(config)# show logSyslog logging: enabled Facility: 20 Timestamp logging: enabled St...
My main pix 506e just lost connection. Yeah the 506 that is acting as the vpn server for all of my locations. i have already checked show version and the pix did not reboot. Is there a way to tell if maybe for some weird ass reason if port e0 are e1 ...
I have a pic 506e and i need to open up port 2122 to accept incoming commections to the internal IP of 10.9.2.202 I have posted my config below.any ideas?PIX Version 6.3(5)interface ethernet0 autointerface ethernet1 autonameif ethernet0 outside secur...
i have a pix 506e in front of my network i have several servers in my network, but there are 6 servers that i am concerned about.is it possable in the pix to put those 6 internal ips in a group and have that group use nating through 1 IP address?
yeah i am connecting the switch and the server to the same cata switch as to use the switch fabric for fast transfers. this transfer is between a server and MAC workstation (ew.....)
great information what i am hoping achieve here is my company deals with LARGE files 2GB to 8GB in size, so by bonding some ports I am looking to solve the network issue of the transfer of files.** I am aware there are other variables like HDD and an...
I am using IpSwitch as my network monitor. Problem is at my data center the pipe coming to my rack goes to a small none managed network HUB then to my pix it goes to the network hub 1st b/c we have 1 drop that is redundant from the DC. so i have 2 ca...
Thank you for your response. But i do Understand what that error means and WHY i am getting it. we do NOT use nat here in my network. so the question was is there a way to have logging ignore that? if not its ok i can deal with it logging that. my ma...
