Question: Is there a set limit that allows only one telnet or ssh session onto the pix (ver 7.0(6)) or is there a command to allow 2 at a time? Thanks in advance.

On a CSM v4.2(3) on a 6509: I'm trying to make the real servers have names (like on the local director) instead of IP addresses:VOC-SW15#conf tEnter configuration commands, one per line. End with CNTL/Z.VOC-SW15(config)#mod csm 4VOC-SW15(config-mod...

Scenerio:We have 2 6509's with CSM's (ver 4.2(3)) each in slot 4, setup for failover via interface GigabitEthernet3/1 switchport switchport access vlan 257 switchport mode access no ip addressThese are Full-duplex, 1000Mb/s(same on each)Problem: whe...