Hello,
I have two "outside" sub-interfaces on my ASA5510:
interface Ethernet0/0 speed 1000 duplex full no nameif no security-level no ip address!interface Ethernet0/0.10 vlan 10 nameif isp1 security-level 0 ip address 74.123.123.123 255.255.255.0 sta...
Hello,
I have an interesting issue and I'll simplify as much as possible. Any help/idea would be appreciated.
Topology: FW --vpn-->R1---R2*---*R3---R4
FW: Site A firewall. vpn establishes from this device.
R1: Site A, IP's range 10.100.x.x/16 va...
Thank You. That was my assumption, but confirmation is always best. I did find out after posting that Cisco does not support an E0/0 access-list propagation to E0/0.X sub-interfaces. Therefore, question 3 is mute, and you confirmed 1 & 2. Thank Y...
Sorry Richard... negitive on both counts. Again, thank you for assisting.
Auto-summary does not apply here; as eigrp only auto summarizes at the classful boundary. As I'm not leaving the 10.0.0.0/8 network, eigrp would never auto summarize. Thus, ...
Everything works fine at the moment... I have backed off the summary commands... no issue to report.
Only when applying summary address, and then only utilizing VPN am I unable to telnet, ssh, or remote desktop to any device (switch, router, server, ...
Richard,
Thank you for responding. Please see attached. "pre sum" are the ip route prior to applying the summary statement. "post" are the ip route after applying the summary statement.
Hope you see something I didn't.
