Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Ok...I'm trying to setup my 851W router. Unable to gain access from the LAN port on 10.10.10.1 I'm able to access through the console port, but the default username/passcode (cisco/cisco) does not work. I've tried the reset button, but still no...
I tried this once, but it didn't work....I tried a power reset with the reset button pushed in. After about 15 seconds of holding down the reset buttonthe router reset to default....yeah it worked and I'm able to program the router, thanks for you a...
Any other suggestions....Cisco/Cisco doesn't work....I keep getting the same response % Authentication failed. Is there a procedure on a power reset to place it back on default?
