Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm using AIR-LAP1522AG-A-K9 and Enterasys switch.How should it be the spanning tree configuration in the ports where are connected the Root Access PointsSTP should be enabled or disabled?
I got these error messages on the AP1522 after that the AP disassociated from the controller WLC440402:06:01[ERROR] spam_l2.c 723: Max retransmissions reached on AP 00:1E:BD:1B:3C:0002:06:21[ERROR] spam_lrad.c 14860: Unable to send Delete-Mobile req...
I have migrated some AP 1300 to lightweight and each AP have between 30 and 60 clients. I'm not sure what is the recommendation about the number of clients per AP
I know that is a best practice don't put more than 20 Access Points in the same vlan where is the management interface of the controller. But i would like to know the recommendation about other vlans.I have serious problems when I put more than 20 AP...
How could i prevent loops between the wired switch and the radio A when i have two RAPs connected to the same switch and one of them loss connection with the ethernet interface for a while
