Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have been trying to get ACLS working on VLANs int?s with limited success. I have version 12, advipservices ios.The following command allows me to access 192.168.133.1 on port 25Permit tcp any host 192.168.133.1 eq 25The following command denies me...
I have 2 525 pix?s in an active passive fail over configuration. I need to split them to use them as individual firewalls, is there anything I should be aware of? Will I need to re-license the individual pix's etc?Thanks
OK, maybe bad wording. So I would have to configure failover in a similar way to, two 515 pix’s for example. failover lan interface interface_name vlan vlanfailover interface ip failover_interface ip_address mask standby ETC? The 6509 will not see th...
