Hi,I have configured my pix506 to support/terminate vpdn sessions local on the pix (vpdn group command).I use pptp and mppe.As I know from where my users come (source ip) I would like to limit vpdn access to the pix for these source ip addresses only...
Hello,I have been searching for a while now for a calculation which tells me the time needed to download a certain filesize from a remote server.I know it depends on TCP windowsize, RTD, packetloss.But what's the equation to calculate download time ?...
Dear readers,I have ADSL + static single IP.Instead of using linux firewall, I would like to use my PIX 506. My HTTP server is at inside at 10.1.1.100. When configuring static to map outside interface address to port 80 at 10.1.1.100 I receive error ...
Users on inside fail to access the webserver on DMZ when using FQDN or global address(195.193.x.y).They can access their own webserver by giving the dmz ip address (192.168.1.98), but not by giving the corresponding global address or the fqdn.Obvious...
Hi Raj,thanks for your reply.I think this would certainly work, but is not an option here as we are not in control of the router in front of the firewall. It is managed by the ISP solely.You are right with regards to the varying sources.However all m...
You can use this card, or PA-8T, but you should not use the next port.The max throughput on PA-4T is 8Mb FullDuplex.(so 2x 4Mb and 2x 0Mb) or (1x8Mb and 3x0Mb).For PA-8T the max throuhgput is 16 Mbregards,diederik
Thanks Nadeem.It works. I wasn't aware of this second syntax of the static command, which was not listed in my cisco pix book.Appreciate your quick reply on this.regards,diederik
Hello Patrick,Initially we didn't have an internal DNS server, but used ISPs one. So users on inside got returned global public address. But website on DMZ was from inside (nor from DMZ) not reachable. In the meantime we have installed a local cachin...
