Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I updated my access point (AP) from firmware version 8.5.171.0 (CAPWAP) to 8.10.196.0 (Mobility Express).I connected to the CiscoAirProvision Wi-Fi network and proceeded with the configuration through the web interface. After restarting the AP, no SS...
• Performed a factory reset without completing the initial controller setup (admin credentials, IP configuration, etc.).• Upgraded the same image AIR-AP1850-K9-8-10-196-0 from ROMMON mode.• Completed the initial controller setup.• Enabled web managem...
show version doesn't work : (Cisco Controller) >show versionIncorrect usage. Use the '?' or <TAB> key to list commands.************************************************* bellow the result of show sysinfos, maybe it could help(Cisco Controller) >show s...
“I followed the procedure ‘Updating Cisco Mobility Express Network using CLI’ on page 57.” see bellow result : Transfer cannot happen because no APs are present.(Cisco Controller) >SHOw INTERface SUMmaryNumber of Interfaces.......................... ...
Hello Mark,It seems that from controller i couldn't not execute the comme show version. check bellow result from other 'show' cmd : (Cisco Controller) >Show interface summaryNumber of Interfaces.......................... 2Interface Name Port Vlan Id ...
Hello Eness, the zip file content no .tar file. The full buldle is a zip file that could only be installed from a controller and i have only one AP that i need to setup like Autonomous ME.
