Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I don not understand what is going on. From R1 I can ping out to the internet but from R2 I can ping 192.168.1.4; the R1's ethernet port and I can ping out to the switch it's connected to, but I can't reach the linksys at 192.168.1.1.
I finnaly got it to work! Props to linksys in making it a PITA. They could have justsaid "Hey we don't understand VLSM, so we are going to use the default mask for that IP address" That would have been much more help than just "Invalid Static Route" ...
That is something I can't get to work. In the linksys I have tried to add a static route but no matter what combination of IP address/subnetmask I use a pop up keeps showing up as "Invaild static route"
lgijssel wrote:The network 10.10.10.0/30 is probably not known on the Linksys and S1.Try using an extended ping with source address 172.168.1.1.If this setup has been working, it will likely respond.regards,LeoLike this?R2#ping ipTarget IP address: 1...
