Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have looked everywhere for a couple of days but I cannot find the answerto the above question. I see the specs for the WS-SUP720-3B and 3BXLbut not the WS-SUP720-BASE with the MSFC3 and PFC3A daughter cards.The 3B can handle 256,000 routes using IP...
I have been reading all over trying to learn as much as I can about routing a single subnet in and out a single BGP peer but I am running out of time.We have a single 6500 with sup720 running BGP between 2 ISP peers. We advertise all out subnets to b...
Hello all!I have a 7513 that has a single FastE circuit and of course a single default route for traffic. I am adding another FastE circuit from another provider and they have provided the /30 WAN and a /24 for LAN.What I am trying to do seems pretty...
I currently have two PIX 515E's, one is located at a collocation the other at our corporate location. We are looking at getting 2 more PIX's so we can have failover ability at both locations and I was told I should look into getting the ASA5500 serie...
How is the 3B better than the SUP720-BASE? I wish there was a spec sheet to compare the BASE and 3B like there is for the 3B and 3BL and 3BXL.Thanks for the help.
I was able to get it to work by setting up 2 new ANNOUNCE lists one for each peer. I use the permit statement for the peer I want the traffic to use and used the deny statement on the peer I do not want to use for the traffic. I then soft reset out f...
The source address would be a local x.x.x.x IP going to any destination and can only use one BGP peer. Is there a way to static route outgoing and incoming traffic for the single subnet using only one BGP peer?I have seen people say you can use local...
