Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am setting up a VPN for multiple users remotley with cisco client v3.0 to PIX firewall 525. I have managed to get the client to connect and get an IP address however I am unable to route traffic to the inside interface network.Looking at the debuig...
It turned out that the problem was not the firewall configuration but rather our router configuration. It was already routing 172.16.0.0 network packets elsewehere. I instead changed the dhcp pool to 192.168.10.0 and now everything works fine.
ArthurThanks for helping tidy up the rules, however I am still getting the same error.Incidently typingcrypto map outside_map 65535 ipsec-isakmp dynamic outside_dyn_map 20 The 20 on the end of the line does not get entered into the pix config, I type...
