Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I restored the HA pair back to Active/Standby.1 remaining issue.I have 3 IPsec Site-to_SIte tunnels.I noticed that when the NEW UNIT becomes ACTIVE that I am unble to pass traffic over the VPN tunnels.When I failback I am able to pass traffic.Any ide...
I want to monitor the througput on the FWSM.I have a 6509 and the FSWM is seated in slot 9. From the switch I perform the following:c06#show etherchannel summaryFlags: D - down P - bundled in port-channel I - stand-alone s - suspended ...
Yes - stateful failover is configured. I have attached the configuration for review.The Sync appears fine. The unit operates fine for a few hours and then the traffic stops getting passed over the VPN tunnels. I perform a failover and traffic passes ...
