Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Installed a brand new 9176i-RTG, connected to network and the VM WLC 9800 (version 17.15.4b) in a lab environment. Been over 30 minutes and nothing is showing up.hooked up a console cable, 115200 baud into the 9176i and it shows <Meraki> I'm tryi...
Trying to lab a few scenarios with a 9800 WLC vm, wondering if anyone can confirm if we add two or three 9166CW-B AP (wifi 6e) to the lab if Cisco will require a license? anyone try this?
Minimum Basic Rate is what I meant. Is this possible to manage through the 9800 gui controller to turn off 802.11B client based devices by setting it to 6 or 12 mbps?
Thank you again. The issue is Fixed !!Solution - setup a trial windows server 2025 vm into the environment, install DHCP, configure dhcp static for 9176iAP with option 43 using F3.xxxx.02. Within 25 minutes, the cw9176i came online this morning wit...
Hi thanks for the follow-up. Yes the dhcp router is configured to assign the 9176i AP a static IP in 192.168.0.81 with option #43 with the hex info as F305.C0A8.0007.02, I'm not sure if this aligns with how the Cisco documents want this setup, F1 v...
