Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have two 3005 concentrators running in parallel and configured for load balancing. Everything works fine. However, when testing the redundancy of this setup by disconnecting the 3005 controlling the client session, the client does not try to ...
I have a 6509 with a Sup2/MSFC2 running in hybrid mode and I'm trying to use TACACS for authentication/accounting on both the SP and MSFC. For some reason, the MSFC and the ACS don't talk, but the SP works just fine.The MSFC config is as follows:aaa ...
You were 100% correct! The switch was using a different source address from the one configured in ACS.Thanks for that ip tacacs source-int command as well. It has proved most useful.
