Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi all,How can we check particular S2S VPN tunnel is up from how much time (what is the up time of S2S VPN tunnel) in ASA firewall.thanx in advancergrds,Naveen
Hi,Recently a audit point was raised by auditor, that the failover key is not enabled for the failover(PIX 515).Please let me know how to enable the failover key between the PIX firewall without any downtime.
dear all,Can u please suggest some good tools(free) or scripts for taking the Automatic backup for PIX/ASA,As we are maintains a good number of devices in diffenert locations.And it becoming Tedious job to take manual backup of all devices every week...
We are facing issue connecting to remote access VPN in Cisco ASA firewall, When connecting to the firewall through remote access VPN, we are receiving error as “ Error 412 : The Remote peer no longer respondingâ€. Even after performing the trouble...
Failed to locate egress interface for UDP from inside:172.16.1.4/53104 to X.X.X.X /53 was a syslog message in ASA Software Version 8.0(3),all the access-list and Natting are fine and even found the traffic is passing other time.what could be the pos...
Hi sakishor,Cureently the firewall are running on the lan based cable failover, there is no failover key set for the same. now i have set the same without any downtime...thanks in advance.
Hi Andrew,the firewalls are in sync and working fine in active-standby mode. the objective is to set the failover key for closure of the audit point without any downtime.
hi andrew,The pix firewalls are already running on active-standby mode, but there is no failover key configured on the same.now the point is to set the failover key on the firewalls without any downtime.thanks in advance.
hi mitang,please use the below command to enable the ssh aceess to fiewall from your noc system (here iam assuming your ip as 192.168.10.10 and this should be inyour inside zone of firewall).use putty to connect through ssh#ssh 192.168.10.10 255.255....
hi mike,your question is not very much clear.hope the below commnand will help you to resolve your issue.(config)# static (inside,outside) tcp interface or publicip www 192.168.10.10 www netmask 255.255.255.255(config)# static (inside,outside) tcp in...
