Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Folks, hoping someone can help me here. I have 2 sites that are connected with a fiber point-to-point WAN circuit. Each site has its own ISP/Internet connection. SiteA is the one I need assistance with. Each site has a single dual-SUP Cisco L3 core a...
Hey folks, this is my first post here so I am hoping someone can assist. I am setting up a site-to-site connection in my lab using ASA firewalls and ISR routers on each end. The goal is to establish an IPSec tunnel between the ASA's and pass GRE tunn...
Hi there. While Cisco is tagging this with a bugid, I do see what you mean about it not technically being a bug. The workaround is pretty simple but in the event multiple images are required, that is a real problem on the lower end platforms for sure...
Folks, hi there, I realize this is a little old, but I just ran into this issue recently with a new FPR-1010. Mine was running at 97% and when it got that high it would cause AnyConnect connections that use SAML for MFA to fail. Apparently there's a ...
Folks, think I might have gotten some more of this. I updated the crypto acl's today to permit GRE between the loopbacks on each side. The tunnel (IPSec and GRE) are still up and passing traffic. So I think the last piece is to create the acl's for t...
Made an additional tweak to NAT in the remote-side ASA.
Changed from:
nat (Inside,outside) source static 10-X-X-X-All 10-X-X-X-All destination static 10-X-X-X-All 10-X-X-X-All no-proxy-arp!
nat (Inside,outside) after-auto source dynamic any interf...
