I'm back again with another question. The diagram below is the layout I'm working with. The ASA and Bordermanger are running side by side for now until I can phase everything over to the ASA, so it makes everything a little complicated right now. ...
Hello,I have just setup a new ASA 5520 with 8.3 OS. I have it setup very basic with 3 interfaces; outside, inside, and management. I have it setup so any users on the inside can get to the internet on the "outside" with Dynamic NAT. However I a...
I only want some Static NAT translations to go throught the one WAN interface, all other translations and general internet traffic will go through the default route interface. Is that possible? Thanks again.Matt
Jennifer,I have a new issue now. I'm trying to move some of NAT translations off of BorderManager onto the ASA. I setup a second WAN interface on the ASA with ip 24.213.128.219/29. Initially there were two subnets on Bordermanger connecting to on...
Jennifer,The default gateway on the switch was set to 10.10.1.2. That is so all our existing clients can still reach the outside through the filtered BorderManager server. I added a second default gateway to the switch of 172.16.160.40 (as you sugg...
Sorry for the delay. There was another router upstream in the same subnet. While it wasn't blocking anything, it must have been interfering with the routing. I just had to restart that router and the ISP's modem. Everything is working great now! ...
