Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I recently acquired a air-ap1141n-a-k9 but I do not know how to set it up. I know this is probably really simple but I looked through the manual and couldn't figure it out.It says "Assign a static IP addresss by conencting to its console port and acc...
Hey,I have a Air-AP1141N-A-K9 and I want to set it up as a repeater bridge. I have the web interface up already. I was wondering how to set it up as a repeater for my primary router. I think it only supports 2.4 GhzThe IP for my primary router is192....
"Console into the AP and make sure you have the 'ap>'."I am not sure what this means. I plugged the ethernet cable into the console port and into my computer but nothing pops up onto my laptop. I don't know where to enter any of this information. Whe...
Where do I enter this information? Do I open the command prompt?"ap>enableap#conf tap(config)#int bv1ap(config-if)#ip add 10.0.0.1 255.0.0.0ap(config-if)#endConfigure your client ip address to be 10.0.0.2, subnet mask is 255.0.0.0. Open a web browse...
It doesn't seem right that you can only do this if you buy a cable. It seems like the box it came in would have that cable if that were the case.Is there a way to do it through the CLI telnet method?
I don't have the equipment to do theThe console portNote: In order to connect to the AP through the console port, connect a nine-pin, straight-through DB-9 serial cable to the RS-232 serial port on the AP and to the COM port o...
