Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Rebooted 2 anchored 5520 WLCs. WLC went fine. WLC 2 lost the factory certificates. The only instructions I can find for this bug are based on an old, very different CIMC gui. Does anyone have steps to resolve the FlexFlash issue using this new inter...
2 5520 WLCsSoftware 8.10.162.0eping and mping okRoughly 1,700 APsModels: 2802, 3802, 9130, 1542We usually receive a steady flow of daily Rogue, Impersonation alarms etc. Not a big deal.No changes have been made to either WLC.Started to notice erratic...
Firmware 4.0(1a)Bios C220M4.4.0.1c.0.0711181559 I compared to functional WLC1 and they are the same versions. When I try to create a Virtual Drive using the above "configure cards" I save and get an error "no SD cards" That can be seen on the General...
Also, after the initial reboot, the CIMC logs showed the following fault: CriticalF1261sys/rack-unit-1/board/storage-flexflash-FlexFlash-0/vd-1equipment-inoperableFlex Flash Virtual Drive 1 (Hypervisor) is Inoperable: Check flex controller propertie...
I do not have an option in CIMC that I can find for Create Virtual Drive. Nothing in the Virtual Drive tab. Looked at Configure Cards link but that is a little different. And doesn't give an option on Virtual Drives. It looks like this screen.
If you see above, I have no certs on the WLC. That is what I am working on. I was looking at a flexflash virtual drive issue being the cause. I don't know what you are suggesting I check outside of show cert all. Results in OP.