Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a wet200 associating with a cisco air-lap1142n-a-k9. It associates fine but two issues.....1. wired clients connected to wet200 will not receive a dhcp 2. I can hardcode ip address but only allows for one client . IfI plug in another client it...
Here are my options under the general screen. Looks like the same area as in the 4400 just worded differently.General 802.3x Flow Control Mode Disable Web Radius Authentication PAP AP Primary Discovery Timeout Back-up Primary Controller IP...
Kamil - I have a similar problem trying to use a wet200 wireless bridge with 5500 controllers. Running AIR-LAP1142N-A-K9 AP's. Do you think upgrading the controllers to 7.0.98 and using passive mode client will allow multiple clients connected to wet...
Kayle - Thanks for the info! I had a feeling we bought the wrong device. When you said enable "802.3 bridging" on the controller and that should allow more than 1 wired, static ip'd client to work, would that be the "802.3x flow Control Mode" option ...
