Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I successfully copied the new IOS image ie4010-universalk9-mz.152-8.E7.bin to flash via TFTP, and configured the boot system variable correctly. However, the switch continues to boot from the old version (E1) and displays a tar checksum error when at...
Hi everyone,
I am attempting to perform a factory reset on a Cisco switch because the enable password has been lost. I am using a console connection with no other cables or devices connected to the switch.
Steps taken so far:
Entered Boot Mode (swit...
I was accessing the SD card, I didn't realize I had the memory card... the sequence was:sd initfind the files:dir sdflash:then delete the filesFinally delete the private-config.text file in the Flash memory
secondfirts
From ROMMON, flash_init was executed and config.text and private-config.text were removed from the flash root. However, the switch continued to load the same configuration.
