Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi allNeed some help regarding ACL configuration.Let's say I have an ASA with 4 interfaces (A, B, C and outside. Security levels for A,B,C are equal, outside is less)All clients on networks A,B,C are allowed to connect to outside. In this case I don'...
Hello,i have some Problem with doing NAT and BGP dynamic routes. I do have the follwing configuration with works perfectly. interface GigabitEthernet0/0.150encapsulation dot1Q 150ip address 90.90.90.33 255.255.255.0ip nat outsideip virtual-reassembly...
Hi,I am only do NAT on this router. BGP Peering is ok.Routing is working fine with BGP routes. (without NAT)Routing table is fine on both sides.Ping is working too. (Without Nat also from End2End. Routed)Notice:i do not have any default route. Does ...
