Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi,Cisco does not support vpn tunnels with both the peers receiving dynamic ip addresses.You can configure vpn tunnel with atleast one of the sites using a static ip addr with any of the following technologies:1) create a normal static to dynamic ips...
Hi,To make this type of an arrangement, you can create seperate groups on th concentrators.Creating seperate groups would ensure creating seperate accesslist for the host that you wish to permit, then respectively bind the desired grp to the desired ...
Hi,On the Pix config, add the following commands on the config mode:isakmp nat-t 20 man iOn the perimeter router make sure that the udp port 500 and 4500 is opened, if not add acl that permits the same.Hope this shud fix the issue..:)for further ques...
