Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, allI'm new to both this community and Cisco in general. We've just put in an 887 router/firewall appliance to protect our Win SBS network. All seemed well - we've used Cisco Config Pro to set up the firewall zones, NAT and ACLs. I've got a ser...
Hi Alain,It was my fault it wouldn't run - I had not gone in to 'enable'.Here are the results:Router#sh run | in intcrypto pki trustpoint TP-self-signed-288785562interface Null0interface BRI0interface ATM0interface ATM0.1 point-to-pointdescription AD...
Hi. Thanks for the response.I tried the command you suggested but got an error:Router(config)#ip audit signature 34911 disable ^% Invalid input detected at '^' marker. I got this both in 'enable' mode and configuration mode. Any ...
Thanks for the quick response, Alain.Running the access list from a terminal session I get:887>sh access-listStandard IP access list 1 10 permit 192.168.1.0, wildcard bits 0.0.0.255Standard IP access list 2 10 permit 192.168.1.0, wildcard bits ...
Sorry it's taken a long while to get back on this - it has been low priorty while sorting other issues out. I've been monitoring the syslog and every time a web site is blocked I get the following:DateTimePriorityHostname Message01-23-201113:34:28Lo...
I've just been advised to move this to the WAN, routing and switching group, rather thanSmall Business which is where it started life. So, over to you guysif anyone can help.Thanks,Steve C
