Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am looking for some clarification on how the Palo VIC presents the vNICs, how to tell/control which vNICs map to which physical ports, and how to best configure my environment for VMWare.Hardware Summary :B250 (full width) blades with 2 Palo VIC...
Manish,related question - what happens if you want to have FCoE storage ports AND the native FC expansion module ?eg - FCoE direct to the disk array to allow blades to get SAN access using FC switching mode, but also NPV/end-host mode to allow a nati...
Ken,I noticed the same thing with my iSCSI QoS assignment : ie until the best effort policy supports jumbo frames, the others wont either. [this caused me some major headaches trying to connect my ESX hosts to the EMC storage!]having said that (i hav...
Jeremy,I did some more digging and found the cause of my ISCSI woes.I have my QoS policies set with VMWare Data NICs getting best-effort, and ISCSI getting gold.best-effort was 'normal' MTU, gold was 9216 MTU.once I changed best-effort to be 9216 as ...
Hi Rob,my system was a 1.3.1(o) upgrade to 1.4.1(i) - looks like all ports are in grace period - not a single one has valid license.roberbur_20110105085058_CORE1NS-UCS01_UCSM.tar uploaded to ftp site for reference************************** EDIT : i c...
Hi Tim,According to VMWare documentation, vSphere only supports 4 10gbit interfaces (regardless of chipset) - im guessing from your post that your old environments had 1gbit NICs ?my experience with B250 (full width) blades in UCS and vSphere 4.1 ins...
