Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have Cisco NAC server ,this is my configuration :NAC - IB - VGusers vlans: 10 ,30 , 60authentication vlan : 11 ,31 , 61 respectivelyI have added the managed subnets after doing the vlan Mapping to these vlansand then I have added vlans 10,30,60 to ...
I have a problem here guys, I will deploy cisco NAC with wireless usersMy scenario is IB-VG , the access points are autonomous there is no WLCthe AP is connected to the switch on a trunk port and I have configured the APwith different SSIDs each one ...
I have 2 CAMs connected to each other as high availabilty. I have configured one as the Masterand the second as the receiver and I use the service IP for the Authorization.and I have followed the exact steps in the 4.8 configuration guide but the syn...
I have a failover CAM configured, one is configured as the Master and the other one is receiver.when I do manual sync between them this is what happen:Successfuly completed pre-sync check with 10.10.80.248then I click continue it fails to sync:this i...
I am configuring NAC for my network IB – VG –L2 as following:CAM vlan 2CAS vlan 3Authentication vlan (31,41)Access vlan (10,20)CAS eth0 native vlan 999CAS eth1 native vlan 998Vlan Mapping untrusted to the trusted as follwing :31 to 10 and 41 to 20 ...
thank you Tiago for your reply but I am sure my configuration is correctafter I have deleted the vlan mapping and managed subnet and added it againseveral times , suddenly it works and users can take IP address . I didn't addany configuration .it is ...
Hi Tiago,thank for your reply. I have configured the AP port on the switch as trunk then I have createdSSID with vlan 31 (Auth vlan) . then I added the vlan mapping and the managed subnet to the CAS and the auth vlan vlan is allowed on the untrusted ...
