I have 2 CAMs connected to each other as high availabilty. I have configured one as the Master
and the second as the receiver and I use the service IP for the Authorization.and I have followed the
exact steps in the 4.8 configuration guide but the sync failed.what is the problem.
*************** Master Log ***************
Starting policy import/export on Policy Sync Master.
Created dump file for policy: Device Management > Filters > Devices (all Access Types other than ROLE and CHECK)
Created dump file for policy: User Management > User Roles > List of Roles/Schedule
Created dump file for policy: Device Management > Clean Access > Clean Access Agent > Role-Requirements
Created dump file for policy: Device Management > Filters > Devices (Access Type ROLE and CHECK only)
Created dump file for policy: User Management > Traffic Control > IP
Created dump file for policy: User Management > Traffic Control > Host
Created dump file for policy: User Management > Traffic Control > Ethernet
Dump file creation is complete.
Created policy import/export dump file.
No file available for policy sync as large object.
Created policy import/export header file.
Created policy import/export tar file.
*************** Receiver Log ***************
Starting policy import on Policy Sync Receiver.
Hash value is a match.
Policy Sync Master and Receiver CAM versions match.
The Policy Sync Reciever is not active, Please retry policy sync later.
Failed to store all policies on Policy Sync Receiver.
Receiver failed sync
