Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
spanning-tree mode pvstspanning-tree extend system-id
The above lines of configuration appear seemingly by default in my IE-3000 switch configurations. I have ran the no command on both lines but cannot seem to remove them. Can anyone offer any adv...
I have 2-off IE-3000-4TC access switches and a stacked 3750X in a REP ring with the following configuration;
3750X
rep admin vlan 31int gi1/0/1switchport mode trunkswitchport trunk native vlan 31rep segment 1 edge primary
int gi2/0/1switchport mode ...
Thank you for the reply.
So I just need to ensure I disable STP on each interface?
If I do so, will I still see STP packets if I put a sniffer on the network?
Configured an access vlan this morning and added some end devices. Ping tested those devices whilst removing links and got zero loss. After all this, REP was working the entire time. I guess I was thrown by the missing switch when only looking at ...
Yes, that output was from the 3750X. Please find the output taken from every switch in the second lab I configured (3 IE-3000 switches in REP ring) below; taken after trunk link removed.
S2#show rep topREP Segment 1Warning: REP detects a segment fai...
