Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
using an 5508 with 8.0121 and 5508 anchor with 8.0.121 and trying to get IPv6 clients to work.
I have enabled Multicast, but not "AP IPv6 Multicast Mode" (under Controller-General), because I can´t see why I should.
The IPv6 clients traffic shou...
I´m have been looking for information concerning IPv6 for clients when using an WLC anchor. I can´t find anything...In my Environment I got 5508 in both "ends" and using 8.0.121 code. The WLAN is not a guest WLAN..
Do anyone of you have any experienc...
I got it to work, the anchored clients gets an IPv6 address from the default router, so that´s fine.
But unfortunately when I´m trying on a 5520, I can´t just enable Global Multicast. When I´m trying, I get:
"Multicast-Unicast mode does not support I...
