Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I run HP/Aruba switches across my school system and have around 600+ MR42s and a handfull of MR52s.Early on and occasionally, I would have and AP go 'bad' in that it will not boot via POE and I bring back to my office and it would work when i used th...
The POE injector is for testing purposes only, I don't have any in production whatsoever. Its not a cabling issue as a known good AP replacing the bad one on the same run will work. And the issue on the bad unit is replicated in a test environment.A...
I killed CDP on my test switch and no joy. Was a good try. There was a time I did disable CDP on my gear. I need to go back to doing that.As for going all same firmware, I am one man with a very large network (public school system) and as much as ...
More information....as for my HP switches...I have a mix of mostly 5400ZL's (POE+ modules) and 2920's. I also have a few 2530's (poe+) and 2520's (poe).So its a mixed bag, and the software revisions are therefore mixed.The firmware on the MRs is 25....
