Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I need assistance in aquiring documentation to setup N+1 redundancy & load balancing between two seperate guest anchor controllers installed in seperate data centers. Can you explaing how it should be setup or point me in the right direction for docu...
I am running WLSE 2.11. I just installed a 12.42ag series WAP as a WDS device, assuming it would work without double checking. RRRRrrr, I never do that, but lately I've had more work then I can deal with. We've been using the 1231. Anyways, when I pe...
I want to do the same thing with my 5508. I would like to run my Hotspot, Guest Access and Office Extend from the same controller. Any documentation or recommendations would be appreciated.Thanks,Gordon
I need to elaborate on my questions:1) Do both of my guest DMZ anchors need to be in a seperate mobility group on their own or can the guest anchors be in completely seperate mobility groups? All 100 + foreign controllers are in seperate mobility gro...
I have to take it seriously. Why? We offer it as a service to very large customers that lease sections of our mainenance facility to perform their needed tasks. It would be nice if I could load balance. This would give me an end around with the netwo...
I have a 5508 WLAN controller with the WPLUS 100 AP license. I want to run this controller as both a guest anchor and the office extend feature at the same time. My question is this: How would the ports be configured on the WLAN controller? Would I h...
