Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
Newbie here. Just studying for the test. I have two small routers back to back on my work bench. Trying to get ripv1 going between them. It seemed to work for a while but it seems the serial port on the router "Joe1700" is not enabled. N...
Hi All,
Newbie here. I have two routers back to back. When using static routes, I can ping back and forth no problem. So I'm thinking the cable is good and the DTE/DCE settings are correct. Next, I delete static routes and configure RIP. At firs...
Hi Mark. You were right. I was not advertising the route of the interface.
Thanks so much. I know RIPv1 is old, but if I cant configure that, how am I ever going to configure OSPF, BGP, etc.....
Thanks again.
Hi Mark,
Thanks for the reply. I think the clocking is fine. I can ping across the link.
The 192 is only on one side.
The real question to me is why and how is a serial interface not enabled? The interface is working, as I said I can ping across...
Hi Cisco Freak,
Your suggestion worked. I'm guessing I can remove the "no valid-update-source" command as well. I will give that a try.
Thank you !!!!!
