Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to setup 2 WLAN's on a Cisco 2504. I have the WLAN setup but when i try and setup a new interface receive and error "Cannot set the port configuration". I have the management interface with no VLAN and setup with our network information...
I was messing around with Guest interface to try and get a second WLAN with it's own DHCP but couldn't get it working. What i really need to do is not allow internet on specific AP's. Is there a way to do this without setting up a second WLAN?
I am new to setting up controllers and just copied the setting from our existing network into there. The AP's are only supporting about 40-50 devices. Is there a way to just have specific AP's not allow internet traffic without setting up a second ...
Here is the picture of my interfaces. First I need to create another one to get traffic off my management since everything is going through that one. When I move it to a different one can I use the same setting except IP address and does it have to...
