Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Everyone,We have a MX100, and are wondering if there is a way to reset the wired.meraki.com. since the one who set it up had left us, and no one else knew what the login credential is. We don't want to do factory reset on this MX100 as well.I h...
We have 6 MR53 APs in office, ceiling mounts, all of them are about 11' above the ground. The Office is around 6k square feet. all in 1 floor, has a brink wall in the middle to session out the area.There is 1 AP (let call it AP1) signal seems weaker ...
Thank you Mark,I changed the password in "Network wise --> Configure --> General"then it seems start working. not sure why, showing password, and typed that password in doesn't work, even tried copy that password and paste in, still not working.But C...
Hi Mark,Yes, we only has 1 firewall here, and I verified the IP address is correct.I also tried to plug a cable to the Management port in the physical device, and nothing get me into the portal.thanks,
I guess, we might need to manually tune this AP to higher power.since our CEO is sitting close to that AP, and his connection was having issue. got quite high in Latency.tested from the Meraki portal -> Client, ping. the average latency was over 200m...
