Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
1.) There is one layer 2 switch which is connected to one Active & one standby router of hsrp; which is also connected to LAN too...Active router replies behalf of virtual router but when active router fails how that layer 2 switch knows immediately....
Hi,if i configure two 1-gig interfaces for etherchannel, after bundling two interface does etherchannel interface become (1+1) 2 Gig in actual.i heard Etherchannel interface becomes 2gig logically (as per this case) but in actual during data flow tim...
Hi, it is 4507R-E having ios: cat4500e-ipbasek9-mz.150-2.SG.bin; previously its cpu utilization was 0 to 1%; suddenly it reached up to 58%; after searching i found its ios bug so upgraded ios to above mentioned one. after that still it shows 45%. I a...
We are also facing same issue, on Cisco 2950. Users are unable to connect on 2950 but able to 2960. Actuall both 2950 n 2960 working fine with primary ACS, but 2950 is not working with secondary ACS (when primary get down) following are debug messa...
Hi Swati, Thanx for ur response...in above doc, there is sentence like "Five-second CPU utilization is expressed as:x%/y%The x% represents total CPU utilization, and y% represents the CPU that is spent at the interrupt level. When you troubleshoot Ca...
