Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Just a quick question:on the inside interface access list on an ASA 5510 (if i am running exchange 2007 on an inside network for instance 192.168.16.0 255.255.255.0) should i have an access list which allows tcp network 192.168.16.0 255.255.255.0 ...
Hi,I'm pretty new to all this and have read a lot. My situation is as follows:I've got a 3750 12 port SFP port switch which connects to 48 ethernetport + 4SFP port switches through a trunk (they are also all trunked between each other and then each o...
yup sorted it out - i just realised that the layer 2 switch had a defined ip address...so took that off. so bottom line:ASA - issue no shutdown command for interface ethernet 2interface ethernet0/2no shut- setup up logical interfaceinterface ethernet...
Yup, am using NAT.Thing is if i am creating the logical subinterface on the ethernet0/2 port for the DMZ connection between the ASA and the Layer 2 switch, i still use the name of the logical subinterface in the global (dmz) command, not the physical...
Sorted out:1. No need for trunk on ASA side - just need to create subinterface3. sorted out this one by blocking vlans through access-lists on the core switch - so cannot ping any longer, etc.Still trying to figure out the second one though...any hel...
